Devices out of homey z-wave network

Comments

• lubbertkramer Member

  April 2017

  Maybe you can give some more information, wich homey version and wich devices (version of the app?) do you use? What do you mean with "exit the homey z-wave network, do you mean the z-wave map under stuff for geeks?
• arno1965 Member

  April 2017

  I am on experimental Homey Firmware Versie: 1.2.0. The Geeks map shows devices without a link to homey. Therefor i can't delete them with homey. 
• arno1965 Member

  April 2017

  Why are devices not being connected to homey? 
• arno1965 Member

  April 2017

  Nodon and Fibaro devices...
• arno1965 Member

  April 2017

  They where first in the network, but now they are not. I thought deleting and adding again would do the trick...
• arno1965 Member

  April 2017

  I use the latest versions of both apps....
• arno1965 Member

  April 2017

  Iemand?
• caseda Member

  April 2017 edited April 2017

  Nodon devices work in broadcast mode, and just send the signal everywhere without waking up fully at all.
  and thus also don't support any neighbor table.
  
  fibaro device it probably is a battery device?
  and was asleep when the initial get all neighboring devices (get mesh network), from alle devices, was asked by homey.
  so no device knows that that device is near it.
  and it was asleep so didn't report itself to homey, and thus no connection to homey directly in the overview
  
  but that is only in the grid oversight, it does not mean it's not connected to homey.
  the mesh overview is not reliable enough for that with battery devices and direct connections to homey.
• arno1965 Member

  April 2017

  Thanks! That explains it all.