This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
Comments
maybe the reset doesn't go well, try using the reset option inside homey:
Homey's settings -> z-wave -> [Remove a Device]
then pressing the small button 3 times
just tested mine again by re-adding it, with all 4 temperature sensors attached and they show the temperature just nicely
there seems to be an issue with the temp sensor for the window/door sensor already, have not looked at the issue yet, will happen soon though, quiet busy now with debugging a lot of stuff in the evenings i have, which this one will be one of the issues.
I'll deffinately keep up with this post. good luck with debugging I have no hurry
even though it uses the same temperature measuring modules, they are not quiet the same device .
And that is also what i thought at first you were talking about "the binary sensor" where your temperature did not come in. (which does work)
but now makes more sense that the temperature did not come in
now it only needs to be accepted and submitted into the app store
(no ETA possible to say, can be tomorrow, can be 3 weeks)
1 re-pair the device, or
2 put homey's id (mostly 1) into association group 1 (you can keep the id in group 3, but it's not really necessary)