This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
sensative strip no alarm
Bought for testing a first Sensative doorstrip. Installed the app and included the strip. All went perfect.
But the final result was negative. Homey always gives "no alarm" with and without magnet at the square end of the strip. The led at the strip itself blinks when I put the magnet away from the strip. Who can help me finding a solution?
But the final result was negative. Homey always gives "no alarm" with and without magnet at the square end of the strip. The led at the strip itself blinks when I put the magnet away from the strip. Who can help me finding a solution?
Comments
No update has been since then, maybee its dependend on a Athom update because zwave is still crap.
Have the issue with all my eight sensative strips
have you woken up the strip? or wait until it did automatically? (it will only send the parameters as soon as the strip wakes up, also know als "battery saving mode")
Does the LED blink when you remove the magnet A?
so no not when the led blinks, it only wakes up after you "removed" the magnet 3 times within 10 seconds
A combination of the above did work for me also.
So save 1,1,0 to raw parameters and the wake it up manually by putting the rond magnet 3 times on the rounded side of the strip.
Thx!
https://github.com/Thorarin/com.sensative/issues/1
if he doesnt react i will have a look and maybee update the app
I'm currently waiting for a fix in the homey firmware to be published. This should happen in 1.0.3.
In addition, a minor update to the app should make sure that initial parameters are set correctly, but I cannot in good conscience publish that change until I've been able to actually test it; so that means waiting for 1.0.3 first.
If you cannot wait for either the firmware or the app update to be released and you're familiar with Git, you can install the version from this branch: https://github.com/Thorarin/com.sensative/tree/driver-rename, but the downside is that you'll have to re-add your Strips and fix all your workflows to go back to the official app.
Perhaps thats the solution.
Than you can replace your homey
@Tante_Linda