This is the forum archive of Homey. For more information about Homey, visit the Official Homey website.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
The Homey Community has been moved to https://community.athom.com.
This forum is now read-only for archive purposes.
KaKu/coco Reciever AWMR-230
Leliekevertje
Member
in Devices
Current situation: I've installed a KaKu/coco reciever AWMR-230 (behind a wallswitch). With a remote control I can switch on/off my light.
I would like to use Homey for switching on/off my lights (holiday/vacation schedule -> trigger on time) but I can't get it to work. As a device I've tried KaKu wallswitch but the wallswitch can only be used as a flowtrigger and not as a THEN THAT.
Please help me out / anyone with a good suggestion?
I would like to use Homey for switching on/off my lights (holiday/vacation schedule -> trigger on time) but I can't get it to work. As a device I've tried KaKu wallswitch but the wallswitch can only be used as a flowtrigger and not as a THEN THAT.
Please help me out / anyone with a good suggestion?
Comments
Wall switch is a transmitter not a receiver. If you add a socket it should work.
copy the signal from the remote.
I use the same remote as in my bedroom. I've tried different channels (I, II, III and IV). The light is responding to the signal only Homey does not recognize it. I'am a bit lost in space...
Rebooting Homey helped...almost...
Now Homey (within devicemanager-> socket) responds to the signal of my remote. Made a simple flow (@ 9:00 lights on) and ran test. Light did not go on. Could it be a range thing? My homey is in the livingroom (backend of my house), and the reciever is at the 2nd floor (frontend of my house).
@BasVanDenBosch: I've googled KaKu code-inspector but could not find info. Can you tell me where I can find it?
Never knew....that's handy ... Homey sees the signal. But the reciever does not respond. I'm guessing that Homey copies the signal and fires it when a flow is triggerd. But my light still does not respond. Could it be a range thing?
solution for this problem??
https://github.com/athombv/homey/issues/922
Perhaps there's two versions? Could you add your findings to bug 922 ? And could you try the steps @baskiers stated in that bug?
@BasVanDenBosch i can add the YCT-102 to homey but not the AWMR-230 following the standard set-up.
Know i use the setup of YC-1000. Than homey recognized the YCT-102. So i setup my AWMR-230 with the setup of YC-1000. Finally i can use my AWMR-230 with homey